Survivor Depot - The ALTERNATIVE to Duct Tape and Plastic _ Protection from Nuclear Biological and Chemical Contaminants!
The IsoArk is a
collapsible isolation chamber that can quickly turn any room or part
of one into a controlled negative-pressure filtered environment. It
can be used either as a rapid-response isolation solution or as a more
efficient, feature-packed and cost-effective alternative to building
permanent isolation rooms.
Why
choose IsoArk?
Safety and Reliability:
The IsoArk is a
self-contained environment proven to filter and contain dangerous
particles and can significantly boost protection in situations where
containment of a biologically dangerous environment is required. Its
sophisticated filtration system uses a combination high-flow HEPA
filtration system and UV radiation to provide the best possible added
protection against contamination threats. The entire system easily
exceeds CDC guidelines for environment infection control and has been
tested to meet the most stringent safety standards
Flexibility:
The IsoArk is
reusable, portable and easily decontaminated, allowing near real-time
customization of response and isolation capacity to the severity and
span of the event rather than attempting to engineer permanent
solutions based on a worst-case scenario.
Cost-Effectiveness:
The IsoArk
provides better protection than permanent isolation rooms at a lower
cost. Turning existing rooms into permanent isolation rooms is a
costly process that varies in complexity based on existing
architecture and engineering. IsoArk provides an inexpensive
alternative that circumvents the need to go through this process,
giving the ability to deploy a cost-effective complete isolation
solution only when needed.
Unrivalled Features:
Beyond just
being a permanent isolation room replacement, IsoArk provides features
that no current isolation solution can claim.
-
Transparent walls allow observation
into contained environment from outside
-
An optional glove/x-ray sleeve panel
allows access to the interior of the chamber from the outside,
preventing the need to enter the chamber for routine checks and
adjustments.
-
Tool portals allow the insertion of
probes, cables and tubes into the chamber, minimizing the need for
equipment decontamination and disposal.
-
The chamber is separated from the
outside by an airlock with wide double swing doors that provides an
interim pressured airspace for personnel entering and exiting the
chamber. The filter automatically switches to a high flush mode for an
adjustable amount of time when someone enters the airlock, maximizing
protection while minimizing delay when leaving the chamber.
-
The filtration system has three flush
rate modes, allowing quick air flushing when needed while minimizing
noise levels and energy use when high flush rates aren’t required. In
low flush mode, the system is quieter than the average cooling fan.
-
The entire system can be packed into
three totes for easy shipment and storage. For additional ease, a
container holding two complete systems is available.
